The eNode4 is an Ethernet node that serves four DMX512 outlets, compatible with the Artnet protocols. All 4 outlets conform to DMX512-A and can be used as input or output. The two Ethernet links on the rear are 10/100BaseTX connections on Neutrik RJ45 Ethercon connectors. The eNode4 embeds a built-in switch fabric which allows you to use the converter as an Ethernet repeater. All configuration are done through the on-board display and push dial. The eNode4 can be set on a flat surface or mounted to a truss structure using the quick lock omega bracket, which is included.
Connections:
2 x 10/100BaseTX Ethernet connections on shielded Neutrik RJ45 Ethercon connectors
4 x DMX512-A in/outputs on shielded and isolated gold plated 5 pin female XLR, with termination (DMX512-A)
Features:
DMX routing, universe setting
Input and output enable / disable
DMX output frame rate setting
Supported protocols: DMX, DMX512-A, RDM, Art-Net™
Protocol selection per port
IP settings
Unit ID and labeling
Ethernet activity indication on front panel
Multi language support
Operation:
Ethernet <-> DMX conversion
Ethernet and DMX Merger
Ethernet and DMX Backup
DMX splitter / booster
DMX trigger. Remote selection of the control source
Built-in DMX soft-patch
DMX Features:
Supported Protocols: DMX512 (1986 & 1990), DMX512-A, RDM ANSI E1.20
DMX Port Direction: Input or output (configurable)
DMX Port Isolation: Optic and galvanic isolation per port
DMX Port Termination/Biasing: Yes
DMX Timing: Frame rate: 10-40fps / Break: 176-352µs
Ethernet Features:
Supported Protocols: Art-Net™, sACN ANSI E1.31
Port Speed: 10/100BaseTX
Port Sensing: Auto-negociation, MDI/MDIX
Size / Weight:
Length: 255mm
Width: 173mm
Vertical Height: 43mm
Weight: 1.6kg
Electrical / Thermal:
AC 100-240V - 50/60Hz
5W Max Power Consumption
2°C to 45°C
